Example Program
Check to make sure you have all these parts and a display.
Install the transistor. Notice how one side is flat. Be sure to install it as shown.
Install the switches.
Install the 26 pin female connector on the bottom of the board and solder it from the top of the board.
Install the display as shown. Solder it to the board. Your kit may have a 8 pin female connector. This part is optional.
Install the resistor and resistor pack.
The resistor pack (9 pin) must be installed as shown. The writing must not be seen from this side.

Solder on back of board. Scotch tape can be used to hold parts in place while soldering. Cut the excess leads off the single resistor.
Writing on this side.
No writing on this side.
Solder the transistor and cut any excess leads.